How do I change where unit health checks and advisory reports print?
From Catalyst
|
This article or section is under development. Be aware: Content will change as the document progresses. |
Summary
Though the Platinum system defaults to a particular printer you may wish to change this. This article explains how to do so for the Vehicle Health Checks.
More Information
Go to " Systems Workshop Maintenance Options Parameters Advisory Work Parameters".
- Here you will see a "Automated reports" section in which are the following 3 options:
- "Report after Jobcard"
- "Check sheet after job card"
- "Report after invoice"
- To change where the above print simply change the "Print Record" to the required number.
- Click the [Close] button.
Information: There will not be an accept prompt as this setting is saved automatically. |
WARNING: For this setting to become active users will need to exit from the Workshop system and re-enter. |
See also
- Creating Workshop Jobs
- How do I Add Advisories to a Workshop Job?
- How do I Create Problem Codes for Workshop Advisories?
- How do I Create Remedy Codes for Workshop Advisories?
- How do I Stop Workshop Advisory Work Report from Printing Automatically?
- How do I Stop Vehicle Health Check Sheets from Printing Automatically?